Gnus Home
[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

6.3.4.3 Mail Source Customization

The following is a list of variables that influence how the mail is fetched. You would normally not need to set or change any of these variables.

mail-source-crash-box
File where mail will be stored while processing it. The default is
`~/.emacs-mail-crash-box'.

mail-source-delete-incoming
If non-nil, delete incoming files after handling them. If t, delete the files immediately, if nil, never delete any files. If a positive number, delete files older than number of days (the deletion will only happen when receiving new mail). You may also set mail-source-delete-incoming to nil and call mail-source-delete-old-incoming from a hook or interactively. mail-source-delete-incoming defaults to 10 in alpha Gnusae and 2 in released Gnusae. See section 10.2.7 Gnus Development.

mail-source-delete-old-incoming-confirm
If non-nil, ask for confirmation before deleting old incoming files. This variable only applies when mail-source-delete-incoming is a positive number.

mail-source-ignore-errors
If non-nil, ignore errors when reading mail from a mail source.

mail-source-directory
Directory where incoming mail source files (if any) will be stored. The default is `~/Mail/'. At present, the only thing this is used for is to say where the incoming files will be stored if the variable mail-source-delete-incoming is nil or a number.

mail-source-incoming-file-prefix
Prefix for file name for storing incoming mail. The default is `Incoming', in which case files will end up with names like `Incoming30630D_' or `Incoming298602ZD'. This is really only relevant if mail-source-delete-incoming is nil or a number.

mail-source-default-file-modes
All new mail files will get this file mode. The default is 384.

mail-source-movemail-program
If non-nil, name of program for fetching new mail. If nil, movemail in exec-directory.


[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

This document was generated by on September, 5 2010 using texi2html